What did you do to your Fiesta ST today ?

[Fiesta fan]

As I was heading to work. I found out one of my taillights went out, when I was stopped at a red light and could see the reflection from the car behind me.

 

[Intuit]

@Fiesta fan - This is a prime opportunity for some Spec-D lights. I used to opportunistically check my tail lights (brake, run, turn-sig) in a store front window reflection.

 

[Bull Run]

I looked that up and found this bit of advice: N-Series valve (with nipple to accept hose) is not recommended for passenger cars with low clearance. Is that of any concern if I've lowered my FiST?

Valve that I have is F106SX I'm lowered by about .75". As you can see in the picture, the valve doesn't stick down that much and the brace and subframe will scrape the ground first.

 

[pixelzombie]

Installed the Rear Torsion Bar, which was easy. To my surprise it did improve the feel of the car in aggressive turns.

 

[Intuit]

Installed the Rear Torsion Bar, which was easy. To my surprise it did improve the feel of the car in aggressive turns.

View attachment 65919

Fiesta ST rear beam is stiffened from the factory.

Engineer Discusses Braking Suspension

View: https://youtu.be/M7YKS9CnpJg


Engineer Discusses Engine Trans

View: https://youtu.be/DI0aPrdP0d0

 

[pixelzombie]

Fiesta ST rear beam is stiffened from the factory.

Engineer Discusses Braking Suspension

View: https://youtu.be/M7YKS9CnpJg


Engineer Discusses Engine Trans

View: https://youtu.be/DI0aPrdP0d0

Great interview, I wonder if any of these guys were let go when the FiST and FOCUS were cancelled.

 

[WolfDampf]

Installed the Rear Torsion Bar, which was easy. To my surprise it did improve the feel of the car in aggressive turns.

View attachment 65919

What brand bar is that?

 

[pixelzombie]

What brand bar is that?

It's from Pierce

https://www.piercemotorsport.com/2014-2019-fiesta-st-rear-torsion-bar/?utm_source=pocket_saves

 

[Intuit]

Great interview, I wonder if any of these guys were let go when the FiST and FOCUS were cancelled.

Don't know but suspect the staff may be "ST" specific... meaning they could be rolled over from one vehicle (project) to the next.

 

[ogminlo]

I installed my fourth HVAC blend door actuator (YH-1896) today. I have the 5th standing by for the day this one also breaks.

While I was in there, I replaced my buzzing interior temp sensor fan module and added the Euro-market isolator for good measure.

3M5Z-19C734-C = replacement interior temp sensor
BA61-19F647-AA = diffuser adapter (Euro market)

 

[Sam4]

Dumped a bunch of leaked oil from #1 and 3 spark plug wells while changing out new NGKs. No smoke! Going to have to suck that up next time....if there IS a next time!