What did you do to your Fiesta ST today ?

SteveS

1000 Post Club
Member ID
#12296
Messages
1,490
Likes
1,781
G2BZ-5827406-CE

Hey everyone. I am looking for the rear passenger side. Is this the correct color for the FiST? Thanks for the help. There are a lot of references but I am not sure if this is correct.
Charcoal is the color for the ST. Stone is the color for regular Fiestas.
 


Member ID
#8395
Messages
314
Likes
228
How is it? What did you feel that made it better a meant to be?
I wasn’t hitting targeted boost numbers (still low due to tuning) until 4600 and it wasn’t stable. I knew it leaked a bit but didn’t realize how bad it was.
Installed the worfab manifold, which fixed the leak. I’m hitting targeted boost now 1200 rpms earlier.
 


dhminer

2000 Post Club
Member ID
#12462
Messages
2,455
Likes
2,880
I wasn’t hitting targeted boost numbers (still low due to tuning) until 4600 and it wasn’t stable. I knew it leaked a bit but didn’t realize how bad it was.
Installed the worfab manifold, which fixed the leak. I’m hitting targeted boost now 1200 rpms earlier.
Have any vdyno logs? Where are you hitting peak torque? I have same manifold and turbo and still don’t make peak torque until 5k
 


Member ID
#8395
Messages
314
Likes
228
Have any vdyno logs? Where are you hitting peak torque? I have same manifold and turbo and still don’t make peak torque until 5k
Have any vdyno logs? Where are you hitting peak torque? I have same manifold and turbo and still don’t make peak torque until 5k
I’ve been tuning it by pulls on the street. No dyno. 5k peak torque sounds about right though for me
 


Cneu

Member
Premium Account
Member ID
#25229
Messages
112
Likes
159
I was pulling into work the other night and heard a very loud/felt a hard clunk from the front right tire. Turns out I destroyed my strut mount. Luckily Napa had it in stock for the oh so totally reasonable price of $80. Took about 45 minutes and we're good as new.
 


Attachments

Member ID
#8027
Messages
651
Likes
305
haha feel free to reach out if anything like this happens again.
Thanks homie. Fortunately it was two miles from home so AAA got me and it was a cheap repair! I still need your Forscan assistance for that camera but I've been slacking on finishing wiring it up.
 


Member ID
#19884
Messages
268
Likes
451
First time doing an oil change after installing the Fumoto oil drain valve. I should've installed it from the get go since I don't have to worry about the oil stream hitting the brace or having to align the drain pan just right.

1742278630099.png
 


TyphoonFiST

9000 Post Club
Premium Account
Member ID
#3304
Messages
11,764
Likes
8,251
First time doing an oil change after installing the Fumoto oil drain valve. I should've installed it from the get go since I don't have to worry about the oil stream hitting the brace or having to align the drain pan just right.

View attachment 65813
Best thing I did too* This is the one I used....comes with a Cap and the hose that you put in and turn to open the valve.

Stahlbus Oil Drain Valve Plug M14x1.5x12mm Steel - Clean, Easy, NO Tool Oil Change - Includes Oil Drain Plug, Washer, Cap, Connector, Silicone Hose

https://a.co/d/gUDgidY
 




Top