hi just wondering if some one can help me

[oohqjokerzoo]

my headgaskets gone dose anyone have the the torque specs for headbolts and the cams caps ??????

 

[SteveS]

1. NOTE: Make sure that the cylinder head is at ambient air temperature before removing the cylinder head bolts.

1. 

1. Support the cylinder head on a bench with the head gasket side up. Check the cylinder head distortion and the cylinder block distortion.
   Refer to: Cylinder Head Distortion (303-00 Engine System - General Information, General Procedures).
   Refer to: Cylinder Block Distortion (303-00 Engine System - General Information, General Procedures).

Installation

1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the head gasket.
   
   NOTE: If there is no residual gasket material present, metal surface prep can be used to clean and prepare the surfaces.
   
   NOTE:
   Material : Motorcraft® Metal Surface Prep / ZC-31-A

1. 

1. NOTE: Make sure that new bolts are installed.
   
   NOTE: Make sure that no fluids are present in the cylinder head bolt threaded bores.
   Torque :
   Stage 1: 5 Nm
   Stage 2: 15 Nm
   Stage 3: 35 Nm
   Stage 4: 90°
   Stage 5: Tighten an additional 90°

 

[oohqjokerzoo]

1. NOTE: Make sure that the cylinder head is at ambient air temperature before removing the cylinder head bolts.

1. View attachment 34486

1. Support the cylinder head on a bench with the head gasket side up. Check the cylinder head distortion and the cylinder block distortion.
   Refer to: Cylinder Head Distortion (303-00 Engine System - General Information, General Procedures).
   Refer to: Cylinder Block Distortion (303-00 Engine System - General Information, General Procedures).

Installation

1. NOTICE: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges that make leak paths. Use a plastic scraping tool to remove all traces of the head gasket.
   
   NOTE: If there is no residual gasket material present, metal surface prep can be used to clean and prepare the surfaces.
   
   NOTE:
   Material : Motorcraft® Metal Surface Prep / ZC-31-A

View attachment 34485

1. View attachment 34484

1. NOTE: Make sure that new bolts are installed.
   
   NOTE: Make sure that no fluids are present in the cylinder head bolt threaded bores.
   Torque :
   Stage 1: 5 Nm
   Stage 2: 15 Nm
   Stage 3: 35 Nm
   Stage 4: 90°
   Stage 5: Tighten an additional 90°

View attachment 34483

thank you do you have to ones for the cams ?????

 

[D1JL]

 

[oohqjokerzoo]

View attachment 34488

thank you

 

[oohqjokerzoo]

View attachment 34488

hi can i ask where you get this info from ?

 

[D1JL]

hi can i ask where you get this info from ?

From the service manual.

 

[oohqjokerzoo]

From the service manual.

do you have a link please ?

 

[D1JL]

do you have a link please ?

https://www.helminc.com/helm/resource-center/ford-service-manuals-repair-information.htm