Hi all, I’m not sure if this is in the right place, my apologies if it is.
A couple of years ago I installed a Turbosmart boost gauge that I had lying around simply so I had a project. Totally unnecessary since I have the Cobb AP that does a much better job. The reason why I’m posting is because when installing the hose, it got a bit disfigured when heating it up to fit over the nozzles on both ends. I plan on replacing it with a new hose. It works but I’d like to do it better. In your experience, what’s the best way to attach them to the nozzles?
A couple of years ago I installed a Turbosmart boost gauge that I had lying around simply so I had a project. Totally unnecessary since I have the Cobb AP that does a much better job. The reason why I’m posting is because when installing the hose, it got a bit disfigured when heating it up to fit over the nozzles on both ends. I plan on replacing it with a new hose. It works but I’d like to do it better. In your experience, what’s the best way to attach them to the nozzles?