• Sign Up! To view all forums and unlock additional cool features

    Welcome to the #1 Fiesta ST Forum and Fiesta ST community dedicated to Fiesta ST owners and enthusiasts. Register for an account, it's free and it's easy, so don't hesitate to join the Fiesta ST Forum today!


What did you do to your Fiesta ST today ?

Messages
105
Likes
15
Location
Mpumalanga
Installed a Milltek catback on my 16 Fiesta today. I knew it wasn’t going to be loud, but it is very close to stock sound. I have the non-res version.

It sounds great in the garage, but on the open road there is barely any noise difference from stock.

I read that sound may increase as carbon builds up. I’m hoping for that!!!

May opt for a downpipe to add sound. Are they difficult to install? I installed the catback myself on jack stands. It was not too bad.





Sent from my iPhone using Tapatalk


Also, does anyone know how to remove the soot on the paint from the exhaust? I tried goo-gone.
Try normal car polish
 


Messages
417
Likes
548
Location
Okemos
I drove mine to run errands and made a few pulls on the way back. Love this thing. Loving the warmer weather this week too. Went from spinning in 3rd to dead hooking 2nd.


Sent from my iPhone using Tapatalk
 


Messages
45
Likes
40
Location
Santa Rosa, CA, USA
She’s gone everyone....wet roads and foggy weather, all it took was one turn, next thing I knew I was tumbling on the road. Thankfully I’m Not injured (except my pride) but she’s done for :(


Sent from my iPhone using Tapatalk
 


Messages
302
Likes
453
Location
Montrose
They're Depo - and I was very surprised that the quality and mechanical adjustment was perfect.

Sent from my LM-G850 using Tapatalk
Thanks for the insight. Euro lights are my next purchase. I was undecided on getting the Hella for $541.62 or Depo for $262.36, but seeing the Depo on yours looks amazing. Also been reading up on all the Euro lights thread to prep for wiring.
 


Sam4

Senior Member
Messages
905
Likes
691
Location
West Chester, PA, USA
How did the one bolt and nut go? That thing was ridiculous when I did mine*

Sent from my SM-N975U1 using Tapatalk
Right? Dropped the f^cking nut, off to Home Depot for a new one, closed my eyes with the diagram in my head....got a thread going....woo hoo it worked!! No apparent improvement.........
 


SteveS

1000 Post Club
Messages
1,430
Likes
1,701
Location
Osage Beach, MO, USA
She’s gone everyone....wet roads and foggy weather, all it took was one turn, next thing I knew I was tumbling on the road. Thankfully I’m Not injured (except my pride) but she’s done for :(


Sent from my iPhone using Tapatalk
Glad you made it. If you want back in there's a pristine Green Envy with Recaros for sale in Tucson, listed on the forum for $11,500
 


Messages
129
Likes
133
Location
Portland
Thanks for the insight. Euro lights are my next purchase. I was undecided on getting the Hella for $541.62 or Depo for $262.36, but seeing the Depo on yours looks amazing. Also been reading up on all the Euro lights thread to prep for wiring.
Thanks! I can't say whether or not the Hella units are worth it as I've never seen them in person, but I have seen TYCs on another fiesta and the chrome finish in the housing was not looking good (cracking and peeling) after what I assume was only a couple of years of use with LEDs. I hope the DEPO units have a bit of longevity in them.

The connector wiring wasn't as bad as I thought it would be, but I should also note I didn't add in a circuit for switching High/Low led intensity. I may change this in the future.

Sent from my LM-G850 using Tapatalk
 


Messages
105
Likes
15
Location
Mpumalanga
Thanks! I can't say whether or not the Hella units are worth it as I've never seen them in person, but I have seen TYCs on another fiesta and the chrome finish in the housing was not looking good (cracking and peeling) after what I assume was only a couple of years of use with LEDs. I hope the DEPO units have a bit of longevity in them.

The connector wiring wasn't as bad as I thought it would be, but I should also note I didn't add in a circuit for switching High/Low led intensity. I may change this in the future.

Sent from my LM-G850 using Tapatalk
Do leds cause damage to housings
 


Flaco

2000 Post Club
Messages
2,338
Likes
1,863
Location
Ellijay, GA, USA
Installed a Milltek catback on my 16 Fiesta today. I knew it wasn’t going to be loud, but it is very close to stock sound. I have the non-res version.

It sounds great in the garage, but on the open road there is barely any noise difference from stock.

I read that sound may increase as carbon builds up. I’m hoping for that!!!

May opt for a downpipe to add sound. Are they difficult to install? I installed the catback myself on jack stands. It was not too bad.

Sent from my iPhone using Tapatalk
Also, does anyone know how to remove the soot on the paint from the exhaust? I tried goo-gone.
I have this same system on my 16 also. I didnt want loud myself. Its my perception that its just barely louder than stock, after you put some miles on it.
 


Dpro

6000 Post Club
Messages
6,359
Likes
5,976
Location
Los Feliz (In the City of Angels) aka Los Angeles
Thanks for the insight. Euro lights are my next purchase. I was undecided on getting the Hella for $541.62 or Depo for $262.36, but seeing the Depo on yours looks amazing. Also been reading up on all the Euro lights thread to prep for wiring.
Hella make the factory ones for Ford. So if you buy Hella your getting unbranded Factory Euro’s, aka oem. Hella is a good lighting company. Depo is a cheaper aftermarket company not oem . Depo’s can be hit and miss. They are also the cheaper alternative for Glass headlights in the BMW E36 community. People use them but they are not great.
 


haste

1000 Post Club
Messages
1,222
Likes
1,266
Location
Eastern
Stabbed the new transmission tonight. Had to wrestle with it due to the odd shape and I didn't drop the sub frame. I was literally about to give up for the night and leave it for tomorrow but it magically slid right in and I got six bolts snugged. Dinner was ready so I left it there for the evening. Really looking forward to getting the car rolling this weekend.

388497_IMG_20201008_175307398.jpg
 




Top